Installation Manual

4
2. Remove either the conduit plug (side) or grommet (top) for side or top wire entry.
3. Prepare the wire entry holes. If using the supplied grommet (plenum rating is not required), set the grommet aside for use later. If
using conduit (not supplied), replace with 25mm or 2/4 in. conduit adapters.
Installing the Back Box
1. Ensure that the support wings are rotated inward, and push the back box through the mounting hole.
2. Replace the other entry opening with the supplied conduit plug.
3. Tighten the two mounting screws to secure the back box using the supplied bit.
4. Feed the wires:
• If using conduit (not supplied): Feed wires through the conduit adapter, into the back box, and attach the conduit to the
adapter.
• If using the grommet (supplied): Feed the wires into the back box; pass the unterminated cables through the grommet; and
then insert the grommet.
5. Terminate the wires using an appropriate connector (not supplied).