Quick Start Guide

TOP COVER DEFOG

Defog function, which heats up the camera to overcome certain extreme weather conditions (e.g., snow or frost) which may harm

the operation of camera, is embedded within this vandal camera. However, in order to prevent a scald incident from happening to

installers, the Defog heating function won’t be activated when the top cover is detached from the camera body as shown in the

following figure where a button at the camera body (marked red) is not pressed by the salient point of top cover (marked green).

Instead, when the salient point presses the button of camera body, the heating function will activate automatically.

POSITION THE CAMERA

 Pan Adjustment (A): Rotate the lens base until you are satisfied with the field of view. Note that the side conduit hole of

the lower case is the point where the camera lens shouldn’t be rotated over.

 Horizontal Rotation (B): Rotate 3D assembly in the lens base, but do not turn assembly more than 355° as this may

cause the internal cables to be twisted, disconnected, or broken.

 Tilt Adjustment (C): Lift to open the inner liner, and tilt the camera lens to your desired angle. Restore the inner liner

back to its default position after adjustment.

NOTE: Limitation for three axes position: Pan range: ±177°, Rotate range: ±177°, Tilt range: 35°～ 90°

ADJUSTING THE FOCUS

1. View the camera image using the browser (refer to the user manual).

2. Use the settings in the Web interface (refer to the user manual) to adjust the zoom and focus of the lens to the desired

field of view.

3. Also, the focus can be adjusted by moving the zoom slider and using the Focus options in the live webpage.

NOTE: Focus adjustment is done exclusively with Web UI.