Quick Start Guide

WALL SURFACE MOUNT

Install the environmental vandal dome camera to a wall surface as shown in the following procedure.

1. Based on your needs, use the bottom or side conduit hole on the lower case for cable entry and connect the required

cables first. Then mount the lower case on a surface by securing screws (supplied) into the inserted plastic anchors tightly.

2. Align the lower case and the lens base, both of which have a red dot on the top side respectively for aligning

identification. Use the red dots to properly align them and then securely fasten the 3 screws of the lens base to the

bottom case with torx key (supplied).

3. Adjust the focusing position by rotating, panning and tilting the camera lens base. When rotating the camera lens, do not

rotate it over the stop point.

4. Fit the inner liner over the camera lens base until it snaps into the place.

5. Mount the top cover on the lens base, both of which similarly have a red dot for aligning identification. Be aware that the

red dot of top cover is within interior instead of top side.

6. Use the torx wrench (supplied) to tighten the 3 top cover screws to complete mounting.

NOTE: Please properly lock the conduit hole plug on the unused hole. For example, lock the side conduit hole with the

plug while using the bottom conduit hole for cable entry and vice versa.

Tightening torque: 8 ~ 10kg/cm

(17.64 ~ 22.05 lb/in)

Tightening torque: 8 ~ 10kg/cm

(17.64 ~ 22.05 lb/in)