User Manual

12
2.3.3 Connecting the Wires
After disassembling, the I/O interfaces will be seen on the rear of the lens base.
 Connect the power cable to the power port via one of the following 3 alternatives.
 AC 24V: Connect a power cable that supplies AC24V power source to the power terminal.
 DC 12V: Connect a power cable that supplies DC12V power source to the power terminal.
 PoE+ (Class 4): Connect an Ethernet cable terminated with RJ-45 connector to the PoE+ RJ-45 port for both power
supply and network connectivity purposes simultaneously.
 Insert audio in/out cables and alarm in/out cables to the corresponding terminals of the camera if required.
FIGURE 2 - 2: REAR SIDE FOR WIRING CONNECTION
2.3.4 Mounting the Camera
Step 1. Preparation by Disassembling
 Remove the camera housing, inner liner and bottom case.
FIGURE 2 - 3: DISASSEMBLING THE CAMERA
1. Loosen the 3 top cover
screws by torx wrench
(supplied) followed by
removing the top cover.
2. Lift to open the inner liner.
3. Loosen another 3 screws of
camera lens base via torx
wrench (supplied).
4. Remove the lens base from
the lower case.
1
4
3
2