User Manual

Step 2. Mark Mounting Area

 Use the guide pattern to prepare a mounting area for In-Ceiling Flush Mount.

1. Attach the mounting template on a desired mounting surface (normally for in-ceiling).

2. Drill a round hole (∅198mm) based on the template on the surface to have the camera embedded within the hole later.

FIGURE 2 - 4: MOUNTING TEMPLATE FOR FLUSH MOUNT

 Use the mounting template to prepare a mounting area for Surface Mount.

1. Place the supplied mounting template on a mounting surface. Drill 6 mm (0.2”) outer holes at the T1 or T2 template

positions on the mounting surface. Then insert 4 or 2 supplied plastic anchors into the holes. (T1: for single-gang socket,

T2: for double-gang socket, if applicable on mounting surface)

2. If you want to feed wiring from the hole on the top of the lower case, create a circular opening corresponding to the

“Bottom conduit hole” of mounting template on the mounting surface.

3. If feeding wiring from the side of the lower case, you don’t need to drill a hole on the mounting surface. The “Side

conduit hole” indication on the mounting template is for user to identify while mounting.

FIGURE 2 - 5: MOUNTING TEMPLATE FOR SURFACE MOUNT