User Manual

2.3.6 Adjusting the Camera Position

The camera has three axes for adjusting field of view on different applications. While screening live view on your monitor,

adjust the position by procedures below simultaneously for desired focusing position.

 Pan Adjustment (A)

Rotate the lens base until you are satisfied with the field of view. Note that the side conduit hole of lower case is the point

where the camera lens shouldn’t be rotated over.

 Horizontal Rotation (B)

Rotate 3D assembly in the lens base, but do not turn assembly more than 355° as this may have the internal cables

twisted, disconnected, or broken.

 Tilt Adjustment (C)

Lift to open the inner liner, and tilt the camera lens to your desired angle. Restore the inner liner back to its default

position after adjustment.

NOTE: Limitation for three axes position: Pan range: ±177°, Rotate range: ±177°, Tilt range: 35°～ 90°

FIGURE 2 -15: ADJUSTING THE CAMERA POSITION

2.3.7 Adjusting the Focus

1. View the camera image using the browser (refer to 2.4 Connection on page 23).

2. Use the settings in the Web interface (refer to 3.2.3.4 Focus on page 46) to adjust the zoom and focus of the lens to the

desired field of view.

3. Also the focus can be adjusted b moving the zoom slider and using the Focus options in the live webpage.

NOTE: Focus adjustment is done exclusively with Web UI.