User Manual

27
3.2.1 System
Use the System tab to change the device name, configure the time settings, set up the text overlay for the live view, get
backup, display system information and update firmware version. You can also use the System tab to generate a system log,
reboot the camera, or to restore the camera's factory default settings.
FIGURE 3-3: SYSTEM SETTINGS
Generate System Log
1. Click the System tab.
2. Click the Generate System Log button to create a system log that can be used by Pelco Product Support for
troubleshooting.
Contact Pelco Product Support at 1-800-289-9100 (USA and Canada) or [phone] (international).
Reboot Camera
1. Click the System tab.
2. Click the Reboot Camera button to restart the camera. Rebooting the camera does not change the configured
camera settings.
Restore All Camera Defaults
This process cannot be undone; all user and custom settings will be lost.
1. Click the System tab.
2. Click the Restore All Camera Defaults button to restore the camera’s factory default settings.
NOTE: If the camera is not connected to a Dynamic Host Configuration Protocol (DHCP) network, the IP address
settings for the camera will be lost and the server will not recognize the camera. DHCP On is the default setting for the
camera IP address.