User Manual

30
3.2.1.3 System Information
The System Information page fields are read-only and include the firmware version, hardware version, model number, and
serial number of the system are revealed here as below figure. This information is typically required by Pelco Product Support
for troubleshooting purposes.
FIGURE 3-6: SYSTEM INFORMATION
3.2.1.4 Firmware Update
Users can update system firmware if available. All camera motions will shut down during firmware update. Please close any
other screens before firmware update. Never disconnect power or LAN cable during the firmware update process.
Disconnecting power during a firmware update will cause the update to fail. It takes approximately 3 minutes for the unit to
reboot after firmware update process.
FIGURE 3-7: FIRMWARE UPDATE
3.2.2 Network
Use the Network tab to change the camera’s general network settings, select the Secure Sockets Layer (SSL) settings, enable
Secure Shell (SSH), configure 802.1x port security settings, choose SNMP Server, Firewall mode, enable FTP access to this
camera and activate VMS Connectivity with the specific server.
FIGURE 3-8: NETWORK CONFIGURATION