User Manual

36
 Upload Certificate
1. Click the Install New Certificate button located at the bottom of the SSL Configuration page. The Select Certificate
Install Method option buttons appear on the page.
2. Select Upload Certificate, and then click Next. The “Certificate” opens.
FIGURE 3-14: UPLOAD CERTIFICATE
3. Choose the Certificate you want to upload and then click Upload button. The following progress message appears
on the page: “Loading data…”
4. After the certificate is uploaded, select the desired mode.
5. Click Save.
 Delete Certificate
1. Once you successfully upload a certificate, Delete Certificate button will appear at the bottom of the SSL
Configuration page.
2. If you want to delete the certificate, click the Delete Certificate, the following progress message appears on the
page: “Deleting certificate file…”
3. Click Save.
3.2.2.3 SSH
SSH is a user-enabled protocol that allows Pelco Product Support to log on to and service the camera for advanced
troubleshooting purposes.
From this page, users with the appropriate permissions can enable or disable SSH access to the camera.
FIGURE 3-15: ENABLING SECURE SHELL
SSH Settings
1. Select the Enabled check box.
2. Click in the Password box and type a password (4 to 16 alphanumeric characters). Passwords are case-sensitive.
NOTE: The default username is “root” and cannot be changed. The username and password are required when
accessing the camera through a third-party SSH client.
3. Click in the “Re-type Password” box and retype your password.
Click the Save button to save the password and enable SSH, or click the Reset button to clear all of the information
you entered without saving