User Manual

39
3.2.2.6 Firewall
Set the Firewall function. A firewall is a system or group of systems that manages access between two networks.
FIGURE 3-18: FIREWALL CONFIGURATION
Firewall
1. Select Allow or Deny mode to enable this function. The default setting is Off.
2. Check Enabled to enter IP address in the Address field. Up to ten addresses can be enabled for entry.
3. Click the Save button to save the settings, or click the Reset button to clear all of the information you entered
without saving it.
3.2.2.7 FTP
This page will enable or disable FTP access to this camera. In this page, users can activate a FTP Server to access the SD
card for recordings. Enabled the FTP and use this function.
FIGURE 3-19: FTP SETTINGS
FTP Settings
1. Select the Enabled check box to activate the FTP function, and follow the following procedures to set up related
settings.
2. Enter a Username if activated the FTP function.
3. Enter a Password associated with the Username.
4. Re-type Password to confirm it.
5. Set the number of maximum connections by entering a number in the Max Connections field.
NOTE: This is the maximum of FTP Client connections, not the maximum of IE Window’s connections.
6. Click the Save button to save the settings, or click the Reset button to clear all of the information you entered
without saving it.