User Manual

3.2.6.7 SD Record Handler

Save video clip backups from a variety of activated events to an SD card. Before using this function, a SD card must be

installed in the camera beforehand.

NOTE: The SD card must be formatted as FAT32. Other formats are not compatible with the camera.

FIGURE 3-48: SD RECORD HANDLER SETTINGS

1. Check to enable SD Record Handler for Alarm, Motions 1 through 4, Wire Network Lost, Sabotage Detection,

and Audio Detection.

2. Choose either Video only or Audio and Video for Record Type, and choose One Shot or Continuous for Record

Status. Then, set a Clip Duration (5~10 seconds) and Clip Size (10~20 MB).

NOTE: It is required to define duration and size parameters for “One Shot” method, whilst only size value needs to

be defined for “Continuous” method.

3. Set overwrite ON or Off to enable or disable the SD card to be overwritten automatically when the SD card is full

of recordings.

4. Usage: Information of SD card usage.

5. SD Format: Click to erase information off from the SD card.

6. Click the Save button to save the settings, or click the Reset button to clear all of the information you entered

without saving it.

Viewing SD Card Files from a Remote Server

1. Configure the SD Record Handler for Alarm, Motions 1 through 4, Wire Network Lost, Sabotage Detection,

and Audio Detection.

2. Type “ftp://” followed by the IP address of the camera in a Web browser or Windows Explorer.

3. Right-click on a snapshot or recording from the SD card and save the file locally or open the file to view its content.