Sarix® Professional IWP Series Rugged Environmental Wedge Dome Quick Start Guide IWP121-1ES IWP221-1ES C2297M-A-EN (10/20)
Contents Contents ....................................................................................................................................................................................... 2 Important Notices Statement ........................................................................................................................................................ 3 Warranty Statement ..........................................................................................................
Important Notices Statement For information about Pelco’s product-specific important notices and thereto related information, refer to www.pelco.com/legal. Warranty Statement For information about Pelco’s product warranty and thereto related information, refer to www.pelco.com/warranty.
Models Instructions The physical appearances and installation methods for the models indicated within the list below are, by and large, the same. Therefore, please regard use quick guide where we use the example from IWP221-1ES as a reference to apply to all the models.
Description The Sarix® Professional Series IP Rugged Environmental Wedge Dome is ideal for both indoor and outdoor applications.
WALL/CEILING SURFACE MOUNT Install the wedge dome camera to a surface (wall/ceiling) as shown in the following procedure. 1 2 3 4 1. Loosen the 2 screws via torx wrench followed by removing the top cover. Connect PoE port with RJ-45 connector via Ethernet cable that links with PoE compatible network device and wire the audio in/out devices with the audio in/out ports individually if required. Also, Insert micro SD card into the slot if needed. 2.
SURFACE MOUNT WITH IMPEBAP You can mount the camera to a surface with IMPEBAP, a Sarix 4S electrical box adaptor mount for Wedge Dome. Refer to the figures below for surface installation with IMPEBAP. 1 2 3 1. 4 Fix the adaptor plate to the surface embedded with 4S electrical box with 2 screws. Note the hole pattern with “4” indicators that represent the exact holes for 4S installation on the adaptor for proper mounting. 2.
WALL MOUNT WITH IMPPMB-1I Wall mount with IMPPMB-1I requires both the L-shape bracket and the adaptor plate from IMPEBAP. Refer to the figures below for detailed process for Wall Mount with IMPPMB-1I. 1 2 3 4 5 1. Fasten the L-shape bracket onto the desired wall with 4 screws. 2. Further fix the adaptor plate from IMPEBAP onto the L-shape bracket with 2 screws.
POSITIONING & ADJUSTING THE FIELD OF VIEW 1. Loosen the two screws beside the lens as shown in the figure below. 2. Adjust the lens to a desired shooting angle for suitable field of view. NOTE: Make sure to relock the 2 screws tightly after adjustment. The lens can be adjusted vertically & horizontally once the two indicated screws are fully loosened.
Pelco Troubleshooting Contact Information If the instructions provided fail to solve your problem, contact Pelco Product Support at 1-800-289-9100 (USA and Canada) or +1-559-292-1981 (international) for assistance. Be sure to have the serial number available when calling. Do not try to repair the unit yourself. Leave maintenance and repairs to qualified technical personnel only. Note for Dimension Drawings NOTE: VALUES IN PARENTHESES ARE INCHES; ALL OTHERS ARE CENTIMETERS.
