Installation Manual

10 C2271M (9/13)

Installation

NOTE: Pelco megapixel (MPx) lenses have been designed and tested to deliver optimal image quality for

the IXE Series camera. The use of a standard definition lens or any other lens not tested by Pelco on an IXE

Series MPx camera could limit the resolution of the camera, creating poor image quality.

1. Install the lens.

a. Remove the cover from the lens mount.

b. Tighten the lens onto the lens mount. Be careful to prevent dust from entering the space

between the lens and the imager. If necessary, use clean, compressed air to remove any

foreign matter (refer to the instructions shipped with the lens). Make sure the lens does not

touch the camera imager when installed.

c. Connect the auto iris lens to the 4-pin connector located on the side of the camera. Refer to

Figure 2 for the pin connections for the auto iris lens connector.

Figure 2. Lens Pin Connections

2. Install the camera on the mount in the desired location (refer to the Installation/Operation manual

for the recommended mount). The camera can be attached to the mount from either the top or

bottom threaded mounting hole, depending on the type of camera mount used in your installation.

3. Connect the wiring to the camera as follows:

a. Connect the network cable to the RJ-45 network port on the back of the camera.

Refer to Ethernet Wiring Requirement for PoE on page 12 for more information.

b. Connect the Micro USB cable and optional multiconductor cables as follows:

• If using a Pelco accessory: Connect the Micro B USB cable that is supplied with the

Pelco accessory to the accessory port at the rear of the camera.

• (Optional) If using alarms or relays: Connect the 24 AWG, 4-wire multiconductor

cable to the 5-pin removable connector (supplied), and then insert the connector back

into the rear of the camera. This cable is for alarms and relays.

• (Optional) If using audio: Connect the 24 AWG, 4-wire multiconductor cable to the

4-pin removable connector (supplied), and then insert the connector back into the rear

of the camera. This cable is for audio line-in and line-out.

CAUTION: Hot Surface! Always turn off power and allow the unit to cool prior to handling. Failure

to follow these instructions can result in injury.

Pin DC (AID) Auto Iris Lens

1 Control coil negative (–)

2 Control coil positive (+)

3 Drive coil positive (+)

4 Drive coil negative (–)