Installation Manual

8 C2271M (9/13)
Getting Started
Before installing your device, thoroughly familiarize yourself with the information in the installation
section of this manual.
NOTES:
• Pelco recommends connecting the device to a network that uses a Dynamic Host Configuration
Protocol (DHCP) server to address devices.
• Do not use a network hub when configuring the network settings for the device.
• To ensure secure access, place the device behind a firewall when it is connected to a network.
PARTS LIST
USER-SUPPLIED PARTS LIST
In addition to the standard tools and cables required for a video security installation, you will need to
provide the following items:
PRODUCT LABEL
The product label lists the model number, date code, serial number, and Media Access Control (MAC)
address. This information might be required for setup. The product label is located on the top of the
camera.
Qty Description
1 Camera
1 4-pin connector for Audio port
1 5-pin connector for Alarm/Relay port
4 MAC address labels (extra)
1 IXE Series Mini Dome IP Camera Installation manual
1 Important Safety Instructions
1 Resource disc
1 Accessory hardware kit:
1 1/4-20 x 3/8-inch bolt
1 1/4-inch flat washer
1 1/4-inch split washer
Qty Description
1 CS mount megapixel lens (refer to Recommended Lenses on page 7)
1SD card
1 Mounting hardware (refer to Recommended Mount on page 7)
1 RJ-45 connector
1 Cat5 (or higher) cable
1 24 AWG, 4-wire multiconductor cable (if using alarm or relays)
1 24 AWG, 4-wire multiconductor cable (if using line-in and line-out audio)