I N S T A L L A T I O N HKHS3000/HKHS3024 Heater Kits C499M-A (11/05)
Important Safety Instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Do not use this apparatus near water. 5. Only use attachments/accessories specified by the manufacturer. 6. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 7. Refer all servicing to qualified service personnel.
Description The HKHS3000 (120 VAC) and HKHS3024 (24 VAC) are field installed heater kits for the HS3000 and HS3020 high security enclosures. These heater kits provide 30 watts of heat and are thermostatically controlled ON at 40°F (4.44°C) and OFF at 60°F (15.56°C). RECOMMENDED CABLE DISTANCES The following are the recommended cable distances for heater operation when used with a transformer capable of delivering the power requirements. Cable distances are based on a 10% line loss.
Installation To install the HKHS3000 and HKHS3024, perform the following steps: 1. Remove the cover from the enclosure. 2. Attach the PC board/bracket assembly to the studs on the rear end plate (refer to Figure 1 and Figure 3) using the two 1/4-20 nuts supplied. 3. Install the heater pads onto the front of the body (end nearest window) by removing the backing and pressing in place onto the floor of enclosure (refer to Figure 3). 4. Wire per wiring diagram in Figure 2. Figure 1.
Exploded Assembly Diagram Figure 3. HKHS3000/HKHS3024 Exploded Assembly Diagram The following parts list corresponds to the items identified in Figure 3 above. Table A.
C499M-A (11/05)
PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years on FT/FR8000 Series fiber optic products. • Three years on Genex ® Series products (multiplexers, server, and keyboard).
Worldwide Headquarters 3500 Pelco Way Clovis, California 93612 USA USA & Canada Tel: 800/289-9100 Fax: 800/289-9150 International Tel: 1-559/292-1981 Fax: 1-559/348-1120 www.pelco.