® PELCO ® PMC14F 14-Inch Color Monitor Installation/ Operation Manual C1950M (10/98) Pelco • 3500 Pelco Way • Clovis, CA 93612-5699 USA • www.pelco.
CONTENTS Section Page 1.0 GENERAL .................................................................................................. 3 1.1 IMPORTANT SAFEGUARDS AND WARNINGS ............................... 3 1.2 UNPACKING INSTRUCTIONS .......................................................... 4 2.0 DESCRIPTION .......................................................................................... 5 2.1 MODELS ............................................................................................
1.0 GENERAL 1.1 IMPORTANT SAFEGUARDS AND WARNINGS Prior to installation and use of this product, the following WARNINGS should be observed. 1. Installation and servicing should only be done by qualified service personnel and conform to all local codes. 2. Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X ,6 or 6P enclosure, it is designed for indoor use only and it must not be installed where exposed to rain and moisture. 3.
1.2 UNPACKING INSTRUCTIONS Unpack and inspect all parts carefully. Be sure to save the shipping carton and any inserts. They are the safest material in which to make future shipments. If an item appears to have been damaged in shipment, replace it properly in its carton and contact the factory at 1-800-289-9100 or 1-559-292-1981 for a replacement. (International customers fax 1-559-348-1120 for authorization and instructions.
2.0 DESCRIPTION The PMC14F is a high-resolution color video monitor that can be used in desktop applications or rack mounted using the optional RMA14F rack mount kit. The monitor supports both NTSC and PAL video, as well as 120 VAC and 230 VAC input power. An automatic switching system makes all the necessary changes for adapting to the required formats. Manual selection is not required. The PMC14F features audio input and output, and has a steel housing and front panel controls.
3.0 INSTALLATION CAUTION: Do not install this monitor in a location having excessive heat or in any way that obstructs the ventilation openings in the cabinet. Premature component failure or cabinet damage may result. Refer to Table A for the type of video coaxial cable to use. Table A.
CAMERA VIDEO OUT CAMERA INPUT VCR OUT IMPEDANCE AUDIO HIGH 75Ω S-VHS CAMERA IN Figure 2. One Monitor with External Video Equipment MAXIMUM OF THREE MONITORS VCR VIDEO OUT CAMERA INPUT IMPEDANCE AUDIO HIGH 75Ω S-VHS CAMERA OUT OUT OUT IMPEDANCE VIDEO OUT CAMERA INPUT VIDEO OUT CAMERA INPUT AUDIO HIGH 75Ω S-VHS CAMERA IN IN IMPEDANCE AUDIO HIGH 75Ω S-VHS CAMERA IN CAMERA Figure 3.
4.0 OPERATION 4.1 FRONT PANEL CONTROLS Refer to Figure 5 for front panel controls. 1. Press the POWER switch to turn the monitor on. The power LED lamp above the switch will illuminate when the power is applied. 2. Adjust the VOLUME control for the desired audio level. Turn the control clockwise to increase and counterclockwise to decrease. 3. Adjust the CONT. control for the desired overall contrast. Proper adjustment will allow maximum gradations between the darkest and lightest picture contrast.
5.0 MAINTENANCE If the quality of the picture is poor and cannot be improved by making adjustments on the front control panel, inspect all system connections and cable runs. To reduce the risk of electrical shock, do not remove the cover or the back. No userserviceable parts are inside. Refer servicing to qualified personnel or contact the Pelco Customer Department for assistance. Refer to Section 7.0 for warranty and return information.
6.0 SPECIFICATIONS ELECTRICAL Input Voltage: 110-240 VAC, 50/60 Hz Power Consumption: 60 watts Horizontal Resolution: 460 lines (center) 380 lines (corners) Picture Tube: 14 inches (35.56 cm) measured diagonally Effective Picture Size: Height Width 8.27 inches (21.0 cm) 11.0 inches (28.
AC Power Cord: One power cord with grounded plug for 120 VAC One “Euro”-style grounded power cord for 230 VAC Construction: Steel cabinet Finish: Black with black bezel around screen Dimensions: See Figure 6 Unit Weight: 26.75 lb (12.13 kg) Shipping Weight: 32 lb (14.51 kg) ENVIRONMENTAL Operating Temperature: 32° to 106°F (0° to 41°C) Humidity: 0% to 90% (non-condensing) (Design and product specifications subject to change without notice.) 13.00 (33.02) 13.75 (34.93) 14.50 (36.83) 15.
7.0 WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years on FT/FR8000 Series fiber optic products. • Three years on Genex® Series products (multiplexers, server, and keyboard).
