® C1906, C1925, C19125, C1906/PP and C1925/PP Pre-wired Interconnecting Inverting Cables Installation/Operation Manual C930M-E (12/95) Amended 1/96 PELCO • 3500 Pelco Way, Clovis, CA 93612-5699 • (559) 292-1981 • (800) 289-9100 FAX (800) 289-9150 or (559) 292-3827
TABLE OF CONTENTS Section Page 1.0 WARNINGS ........................................................................................................................................ 1 2.0 SCOPE ...............................................................................................................................................2 3.0 DESCRIPTION ...................................................................................................................................2 3.
INSTALLATION AND OPERATION MANUAL MODELS C1906, C1925, C19125, C1906/PP, AND C1925/PP PRE-WIRED INTERCONNECTING INVERTING CABLES 1.0 WARNINGS 1. Installation and Servicing should only be done by Qualified Service Personnel. 2. The installation shall be done in accordance with all local and national electrical and mechanical codes utilizing only approved materials. 3.
.0 SPECIFICATIONS 6.0 OPERATION ELECTRICAL By using the controller, you should be able to control the pan and tilt functions of the pan/tilt and the focus, iris, and zoom functions of the motor operated lens. Connectors: Receiver side Pan/tilt side Cable: CPC, 37 sockets CPC, 14 pins CPC, 28 pins (PP models) 12 conductor with shield, 20 Awg RG59/U GENERAL Cable length: C1906 C1925 C19125 C1906/PP C1925/PP 6 ft (1.83 m) long 25 ft (7.62 m) long 125 ft (38.1 m) long 6 ft (1.83 m) long 25 ft (7.
7.0 TROUBLESHOOTING GUIDELINES 1. If none of the functions in Section 6.1 operate correctly, check the connection of the CPC connectors to the Coaxitron® receiver/driver and pan/tilt. 2. If the connections are loose, tighten the lock ring on the CPC connectors and start the system test procedure in Section 6.1. 3. If the connections are tight, check the Coaxitron® receiver/driver to determine if it is operating correctly.
Figure 2.
Figure 3.
9.0 WARRANTY AND RETURN INFORMATION WARRANTY RETURNS Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years on FT/FR8000 Series fiber optic products. • Three years on Genex® Series products (multiplexers, server, and keyboard).