User's Manual

C1656M-A (2/06)
Endura
™
NVR5000PS
Replacement Power Supply
This document describes how to replace a failed power supply in any of the following:
• NVR5100 Series network video recorder
• SEB5100 Series storage expansion box
• DVR5300 Series digital video recorder
NOTES:
• You can replace one failed power supply without shutting down the unit.
• No tools are required to replace this component.
• The NVR5100 rear panel is shown in this document. The power supplies are in the same locations in the SEB5100 and the DVR5300.
Replacing the Power Supply
1. Review all instructions in this document before proceeding.
2. Identify the failed power supply. The status indicator will be red or dark.
3. Unplug the power cord from the failed power supply as follows:
a. Unplug the power cord for the failed power supply from the power source.
b. Unplug the power cord from the failed power supply at the rear panel of the unit.
4. Using your thumb, lift the power supply latch while holding the pull handle.
Figure 1. Releasing the Power Supply Latching Mechanism
WARNING: For safety, you must unplug the power cord from the wall socket or other power source before unplugging it from the failed power
supply on the unit.
POWER
SUPPLY
LATCH
PULL HANDLE
M
O
DE
L
F
R
E
Q
5
0
/
6
0H
Z
S
a
m
p
le
T
e
xt
A
M
P
S
V
O
L
T
S
S
a
mp
le Te
xt
R
E
V
S
a
mp
le T
e
x
t
03267-39-0020
M
F
G
B
Y
P
EL
CO
,
C
LO
V
I
S
,
C
A
Model
SN
A
u
d
i
o
/
Vi
d
e
o
A
p
p
a
r
a
t
u
s
9
1K
K
M
AD
E
I
N
U
SA
POWER
SUPPLY
STATUS
INDICATOR