Installation Manual

11
5. FCC Class A installations: Attach the ferrite (supplied) to the network cable. Attach the ferrite on the cable as close as possible to
the camera’s RJ-45 network port.
The ferrite must be installed for the camera to meet FCC Class A compliance standards. Failure to correctly install the ferrite can
cause harmful interference to radio communications.
Figure 7: Installing the Ferrite: Pendant Models
Installing the Dome Drive (In-Ceiling)
1. Line up the green and red markings on the dome drive with the green and red arrows inside the back box.
2. Push the in-ceiling dome drive into the clips until both sides click into place. The clips temporarily hold the dome drive into place.
3. Place one hand on or under the dome until the fasteners are secure.
4. Screw in the three captive fasteners until they are secure.
Figure 8: Installing the Dome Drive: In-Ceiling Models
Installing the Dome Drive (Pendant)
1. Line up the green and red markings on the pendant dome drive with the green and red arrows inside the back box.
2. Push the pendant dome drive into the clips until both sides click into place. The clips temporarily hold the dome drive in place.
3. Place one hand on or under the dome until the fasteners are secure.