Operation Manual

2. Enable Audio.

3. Select your audio device.

• Native Line In: (Only available for products with built-in audio support.) Enables audio from a microphone connected to the

audio-in connector.

• Line Out: Enables audio to headphones/speakers connected to the audio-out connector.

4. Select your sample rate. The sample rate is the quality of the audio stream (measured in hertz per second).

5. Select the encoding method.

6. If required, mute the audio device using the Mute option on the Audio Configuration page.

NOTE: Do not use the mute button on your audio device; doing so will override your device’s audio settings.

7. Set the input sensitivity level. Input sensitivity is measured on a scale from 0 to 100 (low to high).

NOTE: If the camera is installed in a noisy environment or the connected microphone has a built-in line amplifier, you should lower

audio sensitivity.

8. Click Save.