Installation Manual

3. Screw the back box onto the pendant mount and apply thread compound (supplied) to the threads on the back box.

NOTE: Thread compound must be applied on both standard and environmental pendants. Not doing so may prevent the units from

being separated in the future.

4. Connect the power wiring. Refer to the figure below and the Wiring section for more information.

Figure 5: Power Wiring Connections: Pendant Models

Figure 6: Alarm/Relay/Audio Connector

# Connection/Feature Description

1 24 VAC Power Supplies power to the camera, and operates heater and blower in environmental units.

2 PoE+/HPoE Switch Switch to choose between PoE+ and HPoE. Must be set to the correct position based on

the type of PoE injector used.

3 RJ-45 Network Port Connects the camera to the IP network and supplies power to the camera through the

network using Power over Ethernet (PoE+ or HPoE). PoE+ will also operate blower in

environmental units. HPoE will also operate heater and blower in environmental units.

4 Alarm, Relay, and

Audio In/Out

An 8-pin connector with one alarm, one relay, and audio in and out.

5 Power LED This LED glows solid green when the power is on. The LED is off when there is no power.