Installation Manual

16
Ethernet Wiring Requirement for POE+ and HPOE
A Cat5 cable or higher cable (not supplied) is used to connect the RJ-45 network port during the back box installation process. The 8-pin
port includes video through Ethernet, and PoE (PoE+ and HPoE) for the camera. PoE injects power over the same cabling that carries the
network data, eliminating the need for a separate power supply. This simplifies the installation and operation of the camera without
affecting network performance.
NOTE: Heater will be disabled when PoE+ is in use.
Refer to the figure below for pin descriptions.
Figure 1: Cable Pin Descriptions
Table A: Ethernet with POE+ Mode A
Pin Function
1 TX+, PoE 1-2
2 TX–, PoE 1-2
3 RX+, PoE 3-4
4 Not used
5 Not used
6 RX–, PoE 3-4
7 Not used
8 Not used
Table B: Ethernet with PoE+ Mode B (Sheet 1 of 2)
Pin Function
1TX+
2TX–
3RX+
4 PoE 1-2
5 PoE 1-2
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
8
8
1
1