® HS3000/HS3020 High-Security Enclosures Installation/ Operation Manual C483M-E (9/97) Pelco • 3500 Pelco Way, Clovis, CA 93612-5699 • USA • www.pelco.
CONTENTS Section Page 1.0 GENERAL .................................................................................................. 1 1.1 IMPORTANT SAFEGUARDS AND WARNINGS ............................... 1 1.2 UNPACKING INSTRUCTIONS .......................................................... 2 1.3 RECOMMENDED TOOLS ................................................................. 2 2.0 DESCRIPTION .......................................................................................... 3 2.1 MODELS .....
1.0 GENERAL 1.1 IMPORTANT SAFEGUARDS AND WARNINGS Prior to installation and use of this product, the following WARNINGS should be observed. 1. Installation and servicing should only be done by Qualified Service Personnel and conform to all Local codes. 2. Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X, 6, or 6P enclosure, it is designed for indoor use only and it must not be installed where exposed to rain and moisture. 3. Only use replacement parts recommended by Pelco. 4.
1.2 UNPACKING INSTRUCTIONS Unpack and inspect all parts carefully. The following parts are supplied: 1 1 1 2 2 2 Camera enclosure 1/4"-drive socket for tamper-resistant screws 7/64" Allen wrench 1/4-20 x 1/2" bolts 1/4" flat washers 1/4" split lock washers Be sure to save the shipping carton and any inserts. They are the safest material in which to make future shipments.
2.0 DESCRIPTION The HS3000 Series is a high security camera enclosure designed for installations such as ATM bank machines, prisons, detention cells, etc., requiring maximum protection from vandalism. In addition, a factory-installed tamper switch is mounted on the secured access cover. Constructed from heavy-gauge steel, the HS3000 Series will accept most CCD cameras with fixed focal length lenses ranging in size from 4mm to 75mm.
3.0 INSTALLATION Before installing the HS3000/HS3020 to a wall or ceiling, make certain that the mounting surface is able to support four times the full load of the enclosure plus all other equipment such as camera, lens, etc. To mount the enclosure to a wall or ceiling, follow the steps outlined below. NOTE: The four (4) fasteners required to secure the enclosure to a wall mounting surface (minimum 3/8" [.952 cm] diameter recommended) are not supplied. 1.
Table A. Video Coaxial Cable Wiring Distances Cable Type* Maximum Distance RG59 RG6 RG11 750 ft (229 m) 1,000 ft (305 m) 1,500 ft (457 m) * Minimum cable requirements: 75 ohms impedance All-copper center conductor All-copper braided shield with 95% braid coverage Table B. 24 VAC Wiring Distances The following are the recommended maximum distances for 24 VAC applications and are calculated with a 10-percent voltage drop. (10-percent is generally the maximum allowable voltage drop for AC-powered devices.
4.0 MAINTENANCE Regularly scheduled maintenance will help prolong the operational life and appearance of the equipment. Clean the plexiglass viewing window regularly with a soft cloth, using a mild, nonabrasive detergent and water solution to help maintain picture clarity.
5.0 EXPLODED ASSEMBLY DRAWING Figure 1. HS3000/HS3020 Exploded Assembly Drawing Table C.
6.0 SPECIFICATIONS MECHANICAL Window: 1/4" (.63 cm) thick, impact and abrasion resistant smoked Lexan™ (1 f-stop attenuation) Camera Mounting: Adjustable tilt table Enclosure Mounting: Maximum Camera/Lens Size Four (4) .390" (.99 cm) diameter holes on protected rear surface Accepts camera/lens combinations (including BNC connector) up to: HS3000 3.75" H x 3.25" W x 9.00" L (9.52 cm x 8.25 cm x 22.86 cm) HS3020 3.75" H x 3.25" W x 18.00" L (9.52 cm x 8.25 cm x 45.
Figure 2.
7.0 WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years on FT/FR8000 Series fiber optic products. • Three years on Genex® Series products (multiplexers, server, and keyboard).
