Q U I C K S TA R T G U I D E ® Spectra III™ Series Spectra III™ SE Series Dome Drive C2472M-A (12/05)
WELCOME Thank you for purchasing Pelco’s Spectra III™ SE/Spectra III™ Series dome system. This manual provides the information required to set up and install the dome drive. Please thoroughly familiarize yourself with the information in this manual before attempting installation. NOTE: This manual does not contain instructions for installing a complete Spectra III SE/Spectra III Series system. For complete instructions refer to the installation packet shipped with the back box.
SW2–Termination Setting When connecting more than one Spectra dome to a single controller, terminate the unit farthest from the controller. Termination is only required for the last dome in the series. The dome drive is shipped from the factory in the unterminated (OFF) position. To terminate the dome drive, set the SW2 switch to the ON position. NOTE: Coaxitron Control - Dome termination is not required. SW3–Baud Settings Pelco’s D-Type controllers are set for 2400 baud.
DOME DRIVE INSTALLATION Install the dome drive. Line up the blue (A) and red (B) tabs with the blue (A) and red (B) labels. Push the tabs in. Insert one side and then the other side. Continue pushing on the ends of the tabs until both sides click into place. Refer to Figure 2. To use your dome system, refer to the Operation and Programming Manual supplied with the dome drive. Figure 2. Dome Drive Installation Table A.
Table B.
Table B.
Table B.
Worldwide Headquarters 3500 Pelco Way Clovis, California 93612 USA USA & Canada Tel: 800/289-9100 Fax: 800/289-9150 International Tel: 1-559/292-1981 Fax: 1-559/348-1120 www.pelco.
