I N S T A L L A T I O N Sarix TM Series ® Thermography Fixed Camera C1331M (5/15)
Contents Important Notices . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Regulatory Notices . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Warranty Statement . . . . . . . . . . . . . . . . . . . . . . . . .
Important Notices REGULATORY NOTICES This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. RADIO AND TELEVISION INTERFERENCE This equipment has been tested and found to comply with the limits of a Class A digital device, pursuant to Part 15 of the FCC rules.
Models SP-TM314 Sarix TM fixed environmental camera, 384 x 288 resolution with 14.25 mm lens, NTSC SP-TM314-X1 Sarix TM fixed environmental camera, 384 x 288 resolution with 14.25 mm lens, PAL 8.3 ips SP-TM335 Sarix TM fixed environmental camera, 384 x 288 resolution with 35 mm lens, NTSC SP-TM335-X1 Sarix TM fixed environmental camera, 384 x 288 resolution with 35 mm lens, PAL 8.
Product Overview Figure 1. Camera Features ì Audio Connectors: Enables optional audio capability. î BNC Connector: Enables analog video output. ï Alarm and Relay Connectors: Enables optional alarms and relays. ñ 24 VAC Connector: Provides power to the unit. ó Micro SD Card Slot: Saves a snapshot image to a micro SD card based on alarm activity. NOTE: The micro SD card must be formatted as FAT32. Other formats are not compatible with the camera.
Installation 1. Mount the camera in the desired location using a recommended mount (refer to the instructions provided with the mount). NOTE: Do not install the camera behind a window or other glass. Glass is opaque to long wave infrared and will block the camera's view. 2. Loosen the two T20 security screws using a T20 security driver bit (supplied), and then remove the back cover. Figure 2. Removing the Back Cover 3. Connect all wires and cables (refer to Figure 1 on page 5). 4.
WIRING A1 NO _ + IN _ + OUT Figure 3. Alarm, Relay, and Audio Connections Table A. Pinouts for Alarm, Relay, and Audio Connections. Pin Group Pin Description A1 Alarm Input Alarm Return NO Normally Open (N.O.) Relay Output. Relay Return – Audio Line-In (negative) + Audio Line-In (positive) – Audio Line-Out (negative) + Audio Line-Out (positive) CONNECTING A RELAY DEVICE NOTE: Relays must be configured using the Web interface. The Sarix TM has one output for activating external devices.
CONNECTING ALARMS NOTE: Alarms must be configured using the Web interface. The Sarix TM provides one alarm input for external signaling devices, such as door contacts or motion detectors. Both normally open and normally closed devices are supported. Supervised Alarms When an alarm is configured as a supervised alarm, the Sarix TM maintains a constant electrical current through the alarm circuit (3.3 VDC, 1 kohm).
Unsupervised Alarms When an alarm is configured as an unsupervised alarm, an alarm is only activated when the normal alarm state (open or closed) changes. Figure 7 illustrates the alarm and no alarm conditions of an unsupervised alarm input. NORMALLY CLOSED NORMALLY OPEN NO ALARM GND +V NO ALARM GND +V ALARM GND +V ALARM GND +V ALARM GND +V NO ALARM GND CUT NO ALARM GND +V +V CUT ALARM GND +V BYPASS BYPASS Figure 7.
CONNECTING AUDIO NOTES: • Improper use of audio/visual recording equipment might subject you to civil and criminal penalties. Applicable laws regarding the use of such capabilities vary between jurisdictions and might require, among other things, express written consent from the recorded subjects. You are solely responsible for ensuring strict compliance with such laws and for strict adherence to any/all rights of privacy and personalty. • The maximum recommended cable length for the audio wiring is 304.
This equipment contains electrical or electronic components that must be recycled properly to comply with Directive 2002/96/EC of the European Union regarding the disposal of waste electrical and electronic equipment (WEEE). Contact your local dealer for procedures for recycling this equipment. REVISION HISTORY Manual # C1331M Date 5/15 Comments Original version. Pelco, the Pelco logo, and other trademarks associated with Pelco products referred to in this publication are trademarks of Pelco, Inc.
Pelco by Schneider Electric 3500 Pelco Way Clovis, California 93612-5699 United States USA & Canada Tel (800) 289-9100 Fax (800) 289-9150 International Tel +1 (559) 292-1981 Fax +1 (559) 348-1120 www.pelco.com www.pelco.
