user manual

RMA14E-BK/RMA14E-GY

Rack Mount Kit

Installation/Operation Manual

Manual C905M (2/96)

1.0 WARNINGS

Prior to installation and use of this product, the following

WARNINGS should be observed.

1. Installation and servicing should only be done by

Qualified Service and Installation Personnel.

2. Installation shall be done in accordance with all

local and national electrical and mechanical codes

utilizing only approved materials.

3. Use only installation methods and materials capable

of supporting four (4) times the maximum specified

load.

2.0 SCOPE

The information within this manual covers the installation

of the RMA14E-BK and RMA14E-GY Rack Mount Kits.

Installation should be in accordance with all applicable

local and national electric codes, utilizing approved

materials only.

Please thoroughly familiarize yourself with the infor-

mation in this manual prior to installation and operation.

3.0 DESCRIPTION

The RMA14E-BK and RMA14E-GY Rack Mount Kits

are designed to provide rack mounting for a single Pelco

PMC14E monitor.

This versatile rack will fit any standard 19 inch wide

console or rack configuration and is available in a black

(RMA14E-BK) or gray (RMA14E-GY) finish.

Pelco • 3500 Pelco Way, Clovis, CA 93612-5699 • USA • (800) 289-9100 or (1-559) 292-1981

FAX (800) 289-9150 or (1-559) 292-3827

PAGE 1
® RMA14E-BK/RMA14E-GY Rack Mount Kit Installation/Operation Manual Manual C905M (2/96) 1.0 WARNINGS 2.0 SCOPE Prior to installation and use of this product, the following WARNINGS should be observed. The information within this manual covers the installation of the RMA14E-BK and RMA14E-GY Rack Mount Kits. 1. Installation and servicing should only be done by Qualified Service and Installation Personnel.
PAGE 2
4.0 SPECIFICATIONS To install the rack kit and monitor, perform the following steps: Dimensions: See Figure 1 Construction: 14-gauge steel Finish: Black or gray polyester powder coat Weight: 9.31 lbs. (4.21 kg) 1. Assemble the rack as shown in Figure 2 using the supplied hardware. While assembling, install all hardware loosely until all components are attached and then finish by tightening all hardware. 5.0 INSTALLATION 2.
PAGE 3
Figure 2.
PAGE 4
6.0 WARRANTY AND RETURN INFORMATION WARRANTY RETURNS Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years on FT/FR8000 Series fiber optic products. • Three years on Genex® Series products (multiplexers, server, and keyboard).