I N S T A L L A T I O N WMVE-SR/WMVE-WT Rugged Environmental Wall Mounts C2253M (1/11)
Important Safety Instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Only use attachments/accessories specified by the manufacturer. 6. Installation should be done only by qualified personnel and conform to all local codes. 7. Use only installation methods and materials capable of supporting four times the maximum specified load. 8. Only use replacement parts recommended by Pelco.
Description The WMVE-SR and WMVE-WT are environmental wall mounts that can be installed directly to a wall or any vertical surface. Power and video wiring can be easily routed through the back of the mounts or through the conduit access located on the bottom of the mount arms. The wall mounts can also be pole mounted using a PA101 pole mount adapter. MODELS WMVE-SR Light gray wall mount specifically designed for use with the IM-VEPM, IE-P, and Camclosure® 2 Series pendant mount adapters.
Installation STANDARD INSTALLATION 1. Using the wall mount as a template, mark the fastener positions on the mounting surface. 2. Prepare the mounting surface. 3. Route the system power and video wiring through the wall mount. 4. Use a minimum of two 1/4-inch fasteners of appropriate type (not supplied) to secure the wall mount to the mounting surface. NOTE: (Outdoor installations only) Seal the fastener holes with an appropriate sealant (not supplied) to prevent water damage.
CONDUIT INSTALLATION 1. Using the wall mount as a template, mark the fastener positions on the mounting surface. 2. Prepare the mounting surface. 3. Remove the conduit cover from the bottom of the mount arm. 4. Route the wiring/cabling through the mount arm. 5. Thread a 3/4-inch conduit fitting (not supplied) into the conduit hole located at the bottom of the mount arm. 6.
Specifications MODELS WMVE-SR Environmental wall mount; for use with IM-VEPM, IE-P, and Camclosure® 2 Series pendant mount adapters. WMVE-WT Environmental wall mount; for use with ID-P pendant mount adapter. MECHANICAL Mounting Method Secure with 1/4-inch fasteners of appropriate type (not supplied); up to 4 fasteners can be used. Cable Entry Through the back of the mount and one 3/4-inch conduit access on the bottom of the mount.
PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment.
www.pelco.