User manual

and mmol/l (millimol per litre - international
unit for the hardness of water).
The softener should be adjusted according
to the hardness of the water in your area.
Your local Water Authority can advise you on
the hardness of the water in your area.
The water softener must be set in two
ways: manually, using the water hard-
ness dial and electronically.
Water hardness Adjusting the water hardness setting Use of
salt
°dH °TH mmol/l manually electronically
51 - 70 91 - 125 9,1 - 12,5 2 level 10 yes
43 - 50 76 - 90 7,6 - 9,0 2 level 9 yes
37 - 42 65 - 75 6,5 - 7,5 2 level 8 yes
29 - 36 51 - 64 5,1 - 6,4 2 level 7 yes
23 - 28 40 - 50 4,0 - 5,0 2 level 6 yes
19 - 22 33 - 39 3,3 - 3,9 2 level 5 yes
15 - 18 26 - 32 2,6 - 3,2 1 level 4 yes
11 - 14 19 - 25 1,9 - 2,5 1 level 3 yes
4 - 10 7 - 18 0,7 - 1,8 1 level 2 yes
< 4 < 7 < 0,7 1 level 1 no
Setting manually
The dishwasher is factory set at position
2.
1. Open the dishwasher door.
2. Remove the lower basket from the dish-
washer.
3. Turn the water hardness dial to position
1 or 2 (see chart).
4. Replace the lower basket.
Setting electronically
The dishwasher is factory set at level 5.
1. Press the On/Off button. The dishwasher
must be in setting mode.
2. Press and keep pressed the programme
selection/cancel button until programme
light A flashes and programme light B
comes on with a fixed light. Wait until pro-
gramme light B goes off. The programme
light A goes on flashing and simultane-
ously the End indicator light starts flash-
ing. Wait until programme light B goes off.
the programme light A goes on flashing
and simultaneously the End indicator
light starts flashing. This indicates that
you have activated the electronic setting
function of the water softener. The cur-
rent level is indicated by the number of
flashes of the End indicator light and a
pause of a few seconds.
Examples:
5 flashes, pause, 5 flashes, pause, etc. =
level 5
6 flashes, pause, 6 flashes, pause, etc. =
level 6
3. To change the level, press the pro-
gramme selection/cancel button. Each
time the button is pressed the level
changes. (For the selection of the new
level see the chart).
Examples:
if the current level is 5, by pressing pro-
gramme selection/cancel button once,
level 6 is selected,
if the current level is 10, by pressing pro-
gramme selection/cancel button once,
level 1 is selected.
4. To memorize the operation, switch off the
dishwasher by pressing the On/Off but-
ton.
6