Operation Manual
39
38
Mounting
Installing door panel (see fig. 13)
fig. 13
■ Place the template on the inside of the door
panel. The top of the template is the top of
the door panel.
■ Transfer the markings of the drill holes on
the template onto the door.
■ If the door panel is made of solid wood,
predrill the holes with a 2 mm drill (12 mm
deep).
Note:
Allow for possible differences in the thickness
of the panel (milled hollows or bevelled
edges).
■ Fix the mounting material to the door, as
indicated on the template.
fig. 14b
■ Attach the panel to the door of the
dishwasher by pressing the upper pins
(fig. 15a) into the slots of the plastic section.
Slide the panel up a little. Screw the panel
tight from the inside, as shown in figure 14b.
Adjusting the spring tension (see fig. 15)
fig. 15
■ As standard setting, the door is adjusted to
the lowest spring tension.
■ Increase the tension of the spring by
turning the two adjusting screws in a
clockwise direction with a screwdriver.
The tension of the spring is correct if the
door is in a state of equilibrium when open.
MOUNTING
fig. 14a
■ The dishwasher may be connected either
to a cold-water tap or to a hot-water tap
(maximum 60 °C).
If you connect the dishwasher to a hot-
water tap, the washing time will be
reduced by about twenty minutes.
However, the dishwasher will wash less
efficiently.
■ Do not drill holes in the door or walls. The
dishwasher could be damaged beyond
repair.
Adjusting the height
■ The height of the dishwasher may be
adjusted from 820 to 870 mm by means of
the adjustable feet. Before you do this,
measure the height of the recess.
– It is advisable to place the appliance on a
so-called dishwasher platform.
Ask your kitchen dealer for information.
INSTALLATION