Operation Manual

39
What else you should watch out for
■ Always fit tap, drainage and earthed
plug/wall socket within reach.
■ Make sure that the skirting-board can be
removed. It must be possible to take the
dishwasher out of its recess for
maintenance or repair work.
■ Connect water inlet hose/aquastop to a
self-venting water tap with a 3/4" screw
connection.
Make sure that no dirt remains in a newly-
installed water pipe.
■ The dishwasher may be connected either
to a cold-water tap or to a hot-water tap
(maximum 60 °C).
If you connect the dishwasher to a hot-
water tap, the washing time will be
reduced by about twenty minutes.
However, the dishwasher will wash less
efficiently. The 45 °C programme will
therefore be carried out at a slightly higher
temperature.
■ Do not drill holes in the door or walls. The
dishwasher could be damaged beyond
repair.
Building-in
Fix the adjustable feet with the lock nuts
beneath the side panels of the machine.
Adjusting the height
■ The height of the dishwasher may be
adjusted from 820 to 870 mm by means of
the adjustable feet. Before you do this,
measure the height of the recess.
If there is one central adjustable foot fitted
at the rear of the appliance, this may be
adjusted to the right height from the front
of the appliance.
– It is advisable to place the appliance on a
so-called dishwasher platform.
Ask your kitchen dealer for information.
Mounting
Installing door panel (see fig. 17)
fig. 17
■ Place the template on the inside of the door
panel. The top of the template is the top of
the door panel.
■ Transfer the markings of the drill holes on
the template onto the door.
■ If the door panel is made of solid wood,
predrill the holes with a 2 mm drill (12 mm
deep).
INSTALLATION/MOUNTING