Operation Manual

40
Note:
Allow for possible differences in the thickness
of the panel (milled hollows or bevelled
edges).
fig. 18a
■ Fix the mounting material to the door, as
indicated on the template.
fig. 18b
■ Attach the panel to the door of the
dishwasher by pressing the upper pins
(fig. 18a) into the slots of the plastic section.
Slide the panel up a little. Screw the panel
tight from the inside, as shown in figure 18b.
Adjusting the spring tension (see fig. 19)
fig. 19
■ As standard setting, the door is adjusted to
the lowest spring tension.
■ Increase the tension of the spring by
turning the two adjusting screws in a
clockwise direction with a screwdriver.
The tension of the spring is correct if the
door is in a state of equilibrium when open.
Positioning (see fig. 20)
fig. 20
Note:
You should not allow the hoses to develop
kinks or get flattened during the installation of
the dishwasher in the recess.
MOUNTING