Operation Manual

32
33
5 The electric hob4 The ceramic hob
Removing the decorative glass cover •
Open the decorative lid. Carefully lift the decorative º
glass cover out of the hinged brackets.
Placing the decorative glass cover •
Carefully lower the decorative glass cover into the º
hinged brackets. The decorative lid must only be
placed vertically (see illustration). If this does not work,
then the hinges need to be replaced. Never randomly
switch the location of the hinges, because if they are
wrongly located, then the lid cannot be brought to
a standstill and it can drop down. Attention! Always
check if the decorative lid can be brought to a standstill
after re-installing it. Close the decorative glass cover.
4.3.3 Never use
You should never use scouring agents. These cause scratches in which lime deposits
and dirt can accumulate. Never use sharp objects such as steel wool and scourers. For
cleaning tips refer to the internet site ‘www.atagservice.nl’.
4.4 Faults
If the appliance does not work properly, this does not always mean that it is defective.
Try to deal with the problem yourself first. Phone the service department if the advice
given below does not help. Only authorised personnel may open the appliance or carry
out work on the mains power supply. Damage caused by incorrect connection, incorrect
installation or incorrect use is not covered by the warranty. In the case of faults visit the
internet site ‘www.atagservice.nl’.
FAULT CAUSE SOLUTION
Cooking zones do not get
hot.
Plug not, or not completely,
in the socket.
Fuse(s) in the meter
cupboard defective.
Put the plug into the socket.
Check the fuses in the
meter cupboard.
5.1 Operation
5.1.1 Child security
The control knobs are provided with a child security device. You have to push in the knob
first before you can use the hob.
5.1.2 Switching on and off
First switch on all of the elements in the highest setting for
three minutes without pans.
A special rust-resistant coating will be burnt off. This may result in an unpleasant odour.
This is normal.
Switching on •
Place a pan on a hot plate, press the control knob and º
turn it to the desired setting.The hot plate will then
heat up.
Switching off •
Turn the knob to the 0-setting. Cook with covers on º
the pans: this is quicker and less expensive. The hot
plate remains warm for some time after it has been
switched off. Make use of this extra heat in preparing
your meals.
On/off indicator
As soon as a hot plate is switched on, the indicator lamp
flashes.
1. Burner indication
2. 0-setting
3. High setting
4. Low setting