Installation Guide

ManualsBrandsPELHAM & WHITE ManualsBath72 in. Acrylic Dual-Rest Clawfoot Bathtub in White, Ball-and-Claw Feet and Drain Assembly in Brushed Nickel

TRADITIONAL FLOOR MOUNT TUB FAUCET (cont.)

Tub

See Step 4

T-FB1

U-FRSR

U-SBRC

Floor Flange

(26)

Decorative

Flange (25)

Step 4 Drill (2) 1-1/8” holes into oor on 8” centers

for hot and cold water supplies. If using U-SBRC

support brace, water supply holes must be drilled

at 3-3/4” from drain outlet (center to center). If not

using support brace, holes should be drilled at

2-1/2” mimimum to 3-1/2” maximum from drain outlet

(center to center).

Step 5 If desired, attach U-SBRC support bracket

to risers. See page 20. (Tub model Newcastle does

not have an exposed drain so support brace will not

be used)

Step 6 Slide #25 decorative escutcheon onto

bottom of risers U-FRSR and push part way up.

Screw #26 oor ange onto threaded portion of

each riser until it stops.

Step 7 Insert risers into hole in oor and secure

oor anges with appropriate screws/bolts for your

ooring type. (Hardware not included)

Step 8 Slide decorative escutcheon down to cover

oor ange.

Step 9 Tighten optional support bracket to risers

and drain

Step 10 Attach small end of #18 handshower hose

with #28 washer to outlet on side of #1 handshower

holder.

Step 11 Attach large end of #18 handshower hose

with #28 washer to #6 handshower and place in #1

holder.

Step 12 Connect preferred ½” pipe (supplied by

installer) into female threaded riser U-FRSR from

under ooring. Make hot/cold water connections.

Turn on water and check all connections for leaks.

small end

large end

Dimension X

If using support bracket 3-3/4”

If NOT using support bracket 2-1/2” TO 3-1/2”

NOTE: When using the

U-SBRC support brace

it must be installed onto

faucet risers prior to

securing to oor

Side View End View