Use and Care Guide

1. Unpackage and account for all items before starting installation.

2. Determine location and water flow direction for system

3. Install covers onto bracket orientating the INLET and OUTLET

correctly. Use 4 bolts and washers in each cover to attach.

Assembly

A. (8) Machine Bolts & Washers

B. (3) Lag Bolts & Washers

C. (1) Spanner Wrench

D. (2) 20” Housings w/Covers

E. (1) Chloramine Cartridge

F. (1) Fluoride Cartridge

G. (1) Mounting Bracket

H. (2) Decals

I. (1) Silicone Grease

Items Included:

MODEL: PC200-F

Specications:

Rated Service Flow 5 gpm

Minimum Working

Pressure

25 psi

Maximum Working

Pressure

80 psi

Operating

Temperatures

36°F - 120°F

PH Range 6 - 11

Fluoride Cartridge

(Install as shown)

Housing Cover

Housings

Stand Pipe

O-Ring

EZC-CF_2017-3_R-A

G H

Drains

Fig. A

PAGE 1
MODEL: PC200-F Fig. A Fluoride Cartridge (Install as shown) A B C D Housing Cover O-Ring E F G H Stand Pipe I Items Included: A. (8) Machine Bolts & Washers B. (3) Lag Bolts & Washers C. (1) Spanner Wrench D. (2) 20” Housings w/Covers E. (1) Chloramine Cartridge Housings Drains Assembly 1. Unpackage and account for all items before starting installation. 2. Determine location and water flow direction for system F. (1) Fluoride Cartridge G. (1) Mounting Bracket 3.
PAGE 2
Installation 1. Install bracket to wall using appropriate fasteners (3 qty, 5/16” x 2” stainless lag bolts included). 2. Once the bracket is mounted you can now attach your plumbing to the INLET and OUTLET with 1” male threaded adaptions (not included). (Plumbing a shut off valve prior and a bypass around the unit is recommended). 3. Apply corresponding decals to each of the covers as shown. (Chloramine on Inlet side, Fluoride on Outlet side). 4.