Instructions / Assembly

NS3-6 Rev L —
Pelican NaturSoft NS3/NS6 Salt Free Water Softener/Conditioner
© 2017 Enviro Water Solutions, LLC
3060 Performance Circle, Suite 2, DeLand, FL 32724
Page 7
www.pelicanwater.com
[phone]
Installation
Sediment F
ilter Assembly
Figure 3
Sediment Filter Installation
Figure 4
Notice:
The Sediment Filter Housing comes with a 1” threaded female inlet/outlet and will require additional
fittings to adapt to your plumbing. A shut-off valve is recommended prior to the Sedimnet Filter System.
Sediment Filter Cover
Sediment Filter
O-Ring
Stand Pipe
Blue Filter Housing
Top View Filter
Blue Filter Housing
Inlet Water
Supply
Mounting
Bracket
1. Unscrew the cover from the Blue Filter Housing.
2. Remove the plastic covering
from the Sediment Filt
er.
3. Place the Sediment Filt
er onto the Stand Pipe in the Blue Filter Housing and set aside.
1. Shut off the water.
2. Attach the Filter C
over to the Mounting Bracket using the supplied Bolt Head Screws and
Washers. Make sure to properly orientate the IN and OUT to match your flow pattern.
3. Attach the Mounting Bracket to the wall using the supplied Phillips Head Screws.
4. Hand tighten the Blue Filter Housing and then using the supplied Filter Wrench lightly snug
the housing making sure not to over-tighten. (counter clockwise).
5. Determine the size of your inlet water supply line.