Instructions / Assembly

NS3-6 Rev L —
Pelican NaturSoft NS3/NS6 Salt Free Water Softener/Conditioner
© 2017 Enviro Water Solutions, LLC
3060 Performance Circle, Suite 2, DeLand, FL 32724
Page 8
www.pelicanwater.com
[phone]
Whole House Salt Free Water Softener/Conditioner Tank Installation
1. Level the Pelican Whole House Salt Free Water Softener.
Notice:
If the tank is not level, lift the tank straight up 6 inches and tap it on the ground until the tank stands
vertical. The bottom of the tank is round and the boot allows the tank to stand upright.
Figure 5
2. Determine the size and material of your incoming water supply line from the Sediment Filter System
and choose the appropriate plumbing required to adapt to the 1” Male NPT Assembly.
CAUTION:
Do not over-tighten any of the fittings during installation.
Table 2: Bypass Valve Fittings
Note: The fitting below is designed with a ¼
" give to allow for proper pipe alignment. It will not leak and
is intended to have some flexibility.
3. Install the fittings into the INLET and OUTLET sides of the Bypass Valve. Follow the diagram
supplied with the fitting.
4. Connect the incoming water supply from the Sediment Filter to the fitting on the INLET side of
the Bypass Valve.
5. Connect the outgoing water supply to the OUTLET side of the Bypass Valve.
Part Description Qty.
1" Plastic Male NPT Assembly:
V3007-04 WS1 Fitting 1" Plastic Male NPT
Assembly (2): O-Rings (2), Split Rings
(2), and Connectors (2)
1
bag
T
Incoming
Water
Supply
PVC Fitting*
Bypass
1" NPT Assembly
Valve
Outgoing
ater to
House
W
*Customer supplied,
choose appropriate connection
Salt Free Water
Softener/Conditioner
O-
R
ing
Spl
i
t
Ring
Quick
Connect Nut
INLET
OUTLET