User Manual

This system has been tested according to NSF/ANSI 42 for the reduction of the substances listed below. The concentration of
the indicated substances in the water entering the system was reduced to a concentration less than or equal to the permissible
limit for water leaving the system, as specified in NSF/ANSI 42.
Testing was performed under standard
laboratory conditions, actual performance
may vary. Filter usage and installation
must comply with all state and local laws.
Filter is only to be used on cold water. Do
not use with water that is microbiologically
unsafe or of unknown water quality
without adequate disinfection before or
after the system.
See owner’s manual for operation &
maintenance requirements, manufacturer’s
limited warranty and installation conditions.
Performance Data - Pelican Whole House Filters
Model Replacement Max Operating Pressure Rated Capacity Operating Temp Range Rated Flow Rated Pressure Drop
(At Rated Flow)
PC600 PC600-R 25 - 80 pSI 662,400 gallons 36-120° F 8 gpm 13 pSI
PC1000 PC1000-R 25 - 80 pSI 1,324,800 gallons 36-120° F 12 gpm 13 pSI
PC1354 PC1354-R 25 - 80 pSI 1,987,200 gallons 36-120° F 17 gpm 15 pSI
Data Summary - Pelican Whole House Filters
Model Accumulated
Volume (gal)
Chlorine,Free Available (mg/L) Flow Rate (gpm) Reduction %
Influent Effluent 1
PC600 650,885 gallons 2.05 0.07 8 gpm 96.6%
PC1000 1,301,770 gallons 2.05 0.07 12 gpm 96.6%
PC1354 1,952,655 gallons 2.05 0.07 17 gpm 96.6%
NSF/ANSI 42 Influent Challenge
Chlorine
Minimum Required Reduction Average Reduction % Results
Chlorine Reduction,
Free Available
2 mg/L ±10% ≥50% 95.93% Pass
Certified By IAPMO R&T to NSF/
ANSI Standard 42 for the reduction
of Chlorine Taste & Odor, structural
integrity & NSF/ANSI 61 for
material safety.
Pelican Water Systems
3060 Performance Cir, Suite 2 • Deland, FL • 32724
877-842-1635
|
www.pelicanwater.com