Instructions / Assembly

ManualsBrandsPelican Water ManualsKitchenWhole House Water Filtration System Sediment Filter Replacement

1. Unpackage and account for all items before starting installation.

2. Unscrew Covers from each of the Housings

3. Wrap Teon tape around both ends of the 1” Brass Hex Nipples.

4. Thread rst nipple into the OUTLET of one of the covers and tighten with a wrench.

5. Thread the second cover INLET side to the nipple turning until tight and

orientated correctly.

6. Thread second nipple onto OUTLET of the second cover and tighten with a wrench.

7. Thread the third cover INLET side onto the nipple turning until tight and

orientated correctly.

8. Install the Brass Threaded Plugs to the rst and second covers threaded holes using Teon

tape to seal the threads. Tighten with a wrench.

9. Install the Pressure Gauge to the third cover using Teon tape to seal the threads. Tighten

with a wrench making sure to orientate the pressure gauge to the front for reading.

10. Install covers onto bracket orientating the INLET and OUTLET correctly.

Use 4 bolts and washers in each cover to attach.

Assembly

A. (12) Bolts & Washers

B. (1) Spanner Wrench

C. (2) 1” Brass Hex Nipple

D. (1) Pressure Gauge

E. (2) Brass Threaded Plug

F. (3) 20” Housings w/Covers

G. (1) Sediment Cartridge

H. (1) Chlorine Cartridge

I. (1) Chloromine Cartridge

J. (1) Mounting Bracket

Items Included:

Specications:

Rated Service Flow 5 gpm

Minimum Working

Pressure

25 psi

Maximum Working

Pressure

80 psi

Operating

Temperatures

36°F - 120°F

PH Range 6 - 11

Chlorine Cartridge

Housing Cover

Housing

Stand Pipe

O-Rings

PRC_2016-3_R-A

G H

Summary of content (2 pages)

PAGE 1
Chlorine Cartridge A B C D Housing Cover O-Rings E Housing F G H I Stand Pipe Items Included: A. (12) Bolts & Washers B. (1) Spanner Wrench J. C. (2) 1” Brass Hex Nipple D. (1) Pressure Gauge E. (2) Brass Threaded Plug F. (3) 20” Housings w/Covers G. (1) Sediment Cartridge H. (1) Chlorine Cartridge I. (1) Chloromine Cartridge J. (1) Mounting Bracket Specifications: Assembly 1. Unpackage and account for all items before starting installation. 2.
PAGE 2
Installation 1. Install bracket to wall using appropriate fasteners (not included). 2. Once the bracket is mounted you can now attach your plumbing to the INLET and OUTLET with 1” male threaded adaptions (not included). (Plumbing a shut off valve prior and an external bypass around the unit is recommended). 3. Unwrap cartridges and insert into each of the housings counter clockwise centering on the stand pipe. 4. Thread housings onto the corresponding covers. Snug housings. 5.