Use and Care Manual

PC600-1000 Rev O —
Pelican PC600/PC1000 Premium Whole House Water Filter
© 2017 Enviro Water Solutions, LLC
3060 Performance Circle, Suite 2, DeLand, FL 32724
Page 7
www.pelicanwater.com
[phone]
Water Filter - Carbon Soak
!IMPORTANT!
Your system will not be ready for use for a minimum of 48 hours while the Carbon Soak process takes
place. Please plan your installation accordingly.
Notice:
Water will flow out of the outlet side of the Bypass Valve during this process. Be sure you perform this
series of steps in a location suitable for water flow.
Figure 3
Garden
Hose
Hose Bib
Assembly
Water
Bypass Valve
Whole House Water Filter
INLET
OUTLET
1. Attach a garden hose to the Hose Bib Assembly
2. Connect the Hose Bib Assembly to the inlet side of the Bypass Valve and hand tighten
3. Fill the Whole House Water Filter until water comes out of outlet side of the Bypass Valve.
4. Turn the water off.
5. Remove the garden hose from the Hose Bib Assembly. Do not remove the fitting.
6. Allow the carbon in the Water Filter to soak for a minimum of 48 hours prior to installation.
NOTE: Allowing the Whole House Water Filter to soak longer than 48 hours is completely fine as
it will help with further saturation and minimize the break in period.