Instructions / Assembly

PLS24, PLS48, PLS80 Water Softeners

3060 Performance Circle, Suite 2. DeLand, FL 32724

— Rev A

Page 12

www.pelicanwaterretail.com

Troubleshooting

Problem Solution

Water leaking at the top of the tank around the head. You may need to turn the head to tighten it. The tank

head is pre-installed hand-tight, do not overtighten the

head (just turn it snug).

The tank leans to one side or is not level. If the tank is not level, lift the tank straight up 6 inches

and tap it on the ground until the tank stands vertical.

The bottom of the tank is round and the boot allows the

tank to stand upright.

The Brine Tank has too much water or is not filling

properly.

Check and tighten all fittings on Brine Tank and

Electronic Head to ensure air is not getting into the

Brine Tank Hose.

The system is regenerating but it is not using up any

salt.

If the salt has bridged (too much salt has been added to

the tank and it has formed a solid block of salt), shake

the Brine tank until the block of salt breaks apart.

Unlevel

Tank

Boot

Unlevel

Tank

Boot

Level

Tank

Unlevel

Boot