Full Product Manual

Pelican PSE1800/PSE2000 Premium Whole House Water Filter
& Salt Free Water Softener/Conditioner Combo
© 2018 Enviro Water Solutions, LLC
3060 Performance Circle, Suite 2, DeLand, FL 32724
PSE1800-2000 Rev P
Page 13
www.pelicanwater.com
[phone]
NaturSoft - Media Soak
Figure 9
CAUTION:
The Pelican Whole House Water Filter MUST be in the bypass position during this process (see Figure 9).
1. Open a cold water faucet or test spigot close to the downstream of
the Water Softener.
2. Turn the water back on at the main shut-off valve allowing the system to fill with water. The air
being displaced will escape through the open fixture downstream.
3. Turn the arrows on the Bypass Valve of the NaturSoft Tank into the Bypass Mode position to
bypass the tank. This will allow you to isolate the system and restore water supply to the home/
building during the NaturSoft media soak.
4. Allow the tank to soak for at least 60 minutes.
NaturSoft - Media Flush
CAUTION:
The Pelican Whole House Water Filter MUST be in the bypass position during this process (see Figure 9).
1. After the tank has soaked for 60 minutes, turn the main water supply back on or turn the arrows
on the Bypass Valve back into their original position.
2. Flush the system by running water for 5 minutes at a high flow rate of 5 GPM (this can be
achieved by using a bath tub or more than 3 faucets).
Note: The flush water may have a milky look to it. This is normal as calcium carbonate fines are
flushed from the system.
3. Rinse the system by reducing the flow rate to ½ GPM and run water for 60 minutes (this can be
achieved by turning one faucet ¼ of the way on).
4. Turn the Whole House Water Filter Bypass Valve to the on position (out of Bypass Mode).
IN
OUT
Sediment Filter
Incoming
Water
Supply
Whole House
Water Filter
Wall Wall
Outgoing
Water to
House
Bypass Mode
Salt Free Water
Softener/Conditioner
INLET
OUTLET
INLET
OUTLET