Use and Care Manual

Pelican WF6/WF10 Iron/Manganese Filter and Salt Free Softener
© 2019 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
Page 12
www.pelicanwater.com
[phone]
Installation
Sediment Filter Assembly
Figure 5
Sediment Filter Installation
Figure 6
Notice:
The Sediment Filter Housing comes with a 1” threaded female inlet/outlet and will require additional
fittings to adapt to your plumbing. A shut-off valve is recommended prior to the Sediment Filter System.
Sediment Filter Cover
Sediment Filter
O-Ring
Stand Pipe
Blue Filter Housing
1. Unscrew the cover from the Blue Filter Housing.
2. Remove the plastic covering
from the Sediment Filter.
3. Place the Sediment Filter onto the Stand Pipe in the Blue Filter Housing and set aside.
Top View
Blue Filter Housing
Inlet Water
Supply
Mounting
Bracket
1. Shut off the water.
2. Attach the Filter
Cover to the Mounting Bracket using the supplied Bolt Head Screws and
Washers. Make sure to properly orientate the IN and OUT to match your flow pattern.
3. Attach the Mounting Bracket to the wall using the supplied Phillips Head
Screws.
4. Hand tighten the Blue Filter Housing and then using the supplied Filter Wrench lightly snug
the housing making sure not to over-tighten. (counter clockwise).
5. Determine the size of your inlet water supply line. Reducers may be needed to fit the 1”
Sediment Filter System.
Rev T