Use and Care Manual

Pelican WF6/WF10 Iron/Manganese Filter and Salt Free Softener
© 2019 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
Page 15
www.pelicanwater.com
[phone]
Iron and Manganese Tank Installation
Figure 9
1. Level the Whole House Iron & Manganese Filter.
Notice:
If the tank is not level, lift the tank straight up 6 inches and tap it on the ground until the tank stands
vertical. The bottom of the tank is round and the boot allows the tank to stand upright.
2. Determine the size and material of your incoming water supply line from the In-Line Injection Port
and choose the appropriate fittings required to connect it to the Bypass Valve.
CAUTION:
Do not over-tighten any of the fittings during installation.
Table 2: Bypass Valve Fittings
3. Remove the gray cap from the top of the Whole House Iron & Manganese tank.
4. Screw the Electronic Head onto the tank hand-tight.
5. Install the fittings onto the inlet and outlet, following the arrows on the Bypass Valve and head.
Part Description Qty.
1" PVC Tail Adaptor for
Electronic Head Bypass
2
Salt Free Water
Softener/Conditioner
Whole House
Water Filter
Outgoing
Water to
House
IN
OUT
Sediment Filter
Incoming
Water
Supply
Wall Wall
Solution Tank
Electronic
Head
Chemical Injector
Pump
Spigot
INLET
OUTLET
OUTLET
INLET
Whole House
Iron & Manganese Filter
6. Connect the incoming water supply to the fitting on the inlet side of the Bypass Valve.
7. Connect the outgoing water supply to the outlet side of the Bypass Valve.
8. Firmly press one end of the discharge Tubing Drain Line onto the barbed nose, and secure the
other end of the line to a drain.
Drain Line
Barb
Electronic Head
Bypass Valve
Tail Adaptors
Red Clips
Rev T