Use and Care Manual

Pelican WF6/WF10 Iron/Manganese Filter and Salt Free Softener
© 2019 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
Page 17
www.pelicanwater.com
[phone]
Whole House Water Filter Installation
1. Level the Whole House Water Filter.
Notice:
If the tank is not level, lift the tank straight up 6 inches and tap it on the ground until the tank stands
vertical. The bottom of the tank is round and the boot allows the tank to stand upright.
Figure 10
2. Determine the size and material of your incoming water supply line from the Whole House Iron &
Manganese Filter and choose the appropriate plumbing required to adapt to the 1” Male NPT
Assembly.
CAUTION:
Do not over-tighten any of the fittings during installation.
Table 3: Bypass Valve Fittings
Note: The fitting below is designed with a ¼
" give to allow for proper pipe alignment. It will not leak and
is intended to have some flexibility.
Part Description Qty.
1" Plastic Male NPT Assembly:
V3007-04 WS1 Fitting 1" Plastic Male NPT
Assembly (2): O-Rings (2), Split Rings
(2), and Connectors (2)
1
bag
Salt Free Water
Softener/Conditioner
Whole House
Water Filter
Outgoing
Water to
House
IN
OUT
Sediment Filter
Incoming
Water
Supply
Wall Wall
Solution Tank
Electronic
Head
Chemical Injector
Pump
Spigot
O-Ring
Split Ring
Quick Connect Nut
INLET
OUTLET
OUTLET
INLET
Whole House
Iron & Manganese Filter
Drain Line
Barb
Rev T