Use and Care Manual

Pelican WF6/WF10 Iron/Manganese Filter and Salt Free Softener
© 2019 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
Page 19
www.pelicanwater.com
[phone]
Whole House Salt Free Water Softener/Conditioner Tank Installation
1. Level the NaturSoft Salt Free Water Softener/Conditioner.
Notice:
If the tank is not level, lift the tank straight up 6 inches and tap it on the ground until the tank stands
vertical. The bottom of the tank is round and the boot allows the tank to stand upright.
Figure 11
2. Determine the size and material of your incoming water supply line from the Whole House Water
Filter and choose the appropriate fittings required to connect it to the Bypass Valve.
CAUTION:
Do not over-tighten any of the fittings during installation.
Table 4: Bypass Valve Fittings
Note: The fitting below is designed with a ¼
" give to allow for proper pipe alignment. It will not leak and
is intended to have some flexibility.
3. Install the fitting onto the inlet and outlet sides of the Bypass Valve. Follow the diagrams
supplied with the fitting.
4. Connect the incoming water supply from the outlet of the Pelican Whole House Water Filter to
the inlet side of the Pelican Salt-free Water Softener/Conditioner.
5. Connect the outgoing water supply to the outlet side of the Bypass Valve.
Part Description Qty.
1" Plastic Male NPT Assembly:
V3007-04 WS1 Fitting 1" Plastic Male
NPT Assembly (2): O-Rings (2), Split
Rings (2), and Connectors (2)
1
bag
Split Ring
O-Ring
Quick Connect Nut
Salt Free Water
Softener/Conditioner
Whole House
Water Filter
Outgoing
Water to
House
Whole House
Iron & Manganese Filter
IN
OUT
Sediment Filter
Incoming
Water
Supply
Wall Wall
Solution Tank
Electronic
Head
Chemical Injector
Pump
Spigot
INLET
OUTLET
INLET
OUTLET
Drain Line
Barb
Rev T