Use and Care Manual

Pelican WF6/WF10 Iron/Manganese Filter and Salt Free Softener
© 2019 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
Page 20
www.pelicanwater.com
[phone]
NaturSoft - Media Soak
Figure 12
CAUTION:
The Whole House Water Filter MUST be in the bypass position during this process (see Figure above).
1. Open
a cold water faucet or spigot downstream of the Water Softener.
2. Slowly turn
t
he water back on at the main
shut-off
v
alve allowing
the
system
t
o
fill
with
wate
r
.
The
air
being displaced
will
es
cape through the open
fixt
ure downstream.
3. T
urn
t
he arrows on the Bypass Valve into the Bypass Mode position to bypass the tank. This will
allow you to isolate the tank and restore water supply to the home/building during the NaturSoft
media soak.
4. Allow the tank to soak for at least 60 minutes.
NaturSoft - Media Flush
CAUTION:
The Pelican Whole House Water Filter MUST be in the bypass position during this process (see Figure).
1. After the tank has soaked for 60 minutes, turn the main water supply back on or turn the arrows
on the Bypass Valve back into their original position.
2. Flush the system by running water for 5 minutes at a high flow rate of 5 GPM (this can be
achieved by using a bath tub or more than 3 faucets).
Note: The flush water may have a milky look to it. This is normal as calcium carbonate fines are
flushed from the system.
3. Rinse the system by reducing the flow rate to ½ GPM and run water for 60 minutes (this can be
achieved by turning one faucet ¼ of the way on).
4. Turn the Whole House Water Filter Bypass Valve back into service position. (out of Bypass).
Salt Free Water
Softener/Conditioner
Whole House
Water Filter
Outgoing
Water to
House
Whole House
Iron & Manganese Filter
IN
OUT
Sediment Filter
Incoming
Water
Supply
Wall Wall
Solution Tank
Electronic
Head
Chemical Injector
Pump
Spigot
INLET
OUTLET
INLET
OUTLET
Drain Line
Barb
Rev T