Use and Care Manual

Pelican WF6/WF10 Iron/Manganese Filter and Salt Free Softener
© 2019 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
Page 22
www.pelicanwater.com
[phone]
IMPORTANT!
You will need to manually regenerate (Regen Now) your system prior to use. To do so follow the
programming below. You will not be able to use water for
20 minutes during this process.
1. Using the DOWN button select Manual Regen and press SET.
2. Using the UP or DOWN button select either Regen Now or Regen Tonight.
-Regen Now will start a regeneration process immediately.
-Regen Tonight will regenerate the system at the default regeneration time of 2:00am.
3. Once selected press the SET button to confirm. Gears will make noise and water will start to
flow. Allow the system to regenerate for approximately 20 minutes.
4. Once complete press the MENU button to return to the main menu.
5. The programming is now complete
In the event of spikes in Iron and
Manganese levels you may choose to manually regenerate your
system if you experience colored water from your system.
Step 2: Performing a Manual Regeneration
Notice:
Programming the Electronic Head
Note: Power Sour
ce - For safety reasons the outlet must be protected by a Ground Fault Circuit
Interrupter (GFCI).
Note: Do not make changes to the settings unless instructed by a Technical Support representative.
Your system is pre-set to regenerate every 3 days at 2:00 am, the complete process takes 20 minutes
Step 1: Setti
ng the Date & Time
1. P
r
ess and hold the M
ENU
but
ton
until
you
hear
the
beep
to unlock.
2. Press
MENU button for menu.
3.
Press
SET once
Date & Time Setting is highlighted.
4. Using the UP and DOWN buttons input the correct Date and Time pressing SET after each input.
5. Once set press the
MENU button to return to the main menu.
MENU
SET
Rev T