Use and Care Manual

Pelican WF6/WF10 Iron/Manganese Filter and Salt Free Softener
© 2019 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
Page 8
www.pelicanwater.com
[phone]
Installation Overview
Figure 1
Pre-Installation
Bypass Valve Installation
Salt Free Water
Softener/Conditioner
Whole House
Water Filter
Outgoing
Water to
House
Whole House
Iron & Manganese Filter
IN
OUT
Sediment Filter
Incoming
Water
Supply
Wall Wall
Solution Tank
Electronic
Head
Chemical Injector
Pump
Spigot
INLET
OUTLET
INLET
OUTLET
Figure 2
Whole House Water Filter & Salt Free Water Softener/Conditioner - The Bypass Valve comes pre-
assembled and ready to install with the O-Rings, Split Rings, and Quick Connect Nuts. Push the Bypass
Valve into the head of the Pelican Whole House Water Filter or Salt Free Water Softener/Conditioner with
the unthreaded ends orientated towards the tank and hand-tighten the Quick Connect Nuts.
Whole House Iron & Manganese Filter - If the Red Clips are in the slots (female opening of Electronic
Head) remove them. Push the male O-Ring side of the Bypass Valve into the female opening of the
Electronic Head. Push the Red Clips back into the slots to tighten.
Quick
Connect Nut
Red Arrow
Water Filter
Head
Whole House
Iron & Manganese Filter
Electronic
Head
Bypass
Valve
INLET
OUTLET
Red
Clip
Front View
Whole House Water Filter &
Salt Free Water Softener/Conditioner
Drain Line
Barb
Rev T