User's Manual

PELLA

INSYNCTIVE

INTEGRATED PATIO DOOR SENSOR PRODUCT GUIDE | 11

IMPORTANT NOTES:

• Electrostatic-sensitive. Avoid touching the antenna or circuit

board when changing the battery.

• Failure to change battery promptly when low will impair

INTEGRATED PATIO DOOR SENSOR performance.

• Properly dispose of used batteries based on your local

requirements. A best practice is to dispose of batteries at

your local home chemical collection center. California Only:

Contains perchlorate material. See dtsc.ca.gov/hazardouswaste/

perchlorate for any special handling regulations.

DELETING INTEGRATED PATIO DOOR SENSOR

Deleting INTEGRATED PATIO DOOR SENSORS may be needed if

you no longer have a use for INTEGRATED PATIO DOOR SENSORS.

See Insynctive.Pella.com/Support for how-to videos.

1. Prepare OPEN/CLOSE SENSOR

Sliding Patio Door: Use a small ﬂathead screwdriver to remove the

plastic endcap from the OPEN/CLOSE SENSOR. Grip the edges of

the circuit board and pull it out to gain access to the battery. Slide

out the battery, then slide back in. Install the plastic endcap back

onto OPEN/CLOSE SENSOR.

Hinged Patio Door: Use a small ﬂathead screwdriver to remove

the plastic endcap from OPEN/CLOSE SENSOR. Slide out the

battery, then slide back in. Install the plastic endcap back onto

OPEN/CLOSE SENSOR.

NOTE: Once the battery is removed, you will have 2 minutes to

delete OPEN/CLOSE SENSOR from BRIDGE. If 2 minutes pass

without successful deletion, remove and insert the battery again.

You are ready to delete OPEN/CLOSE SENSOR from BRIDGE.

2. Delete OPEN/CLOSE SENSOR from BRIDGE

Each INTEGRATED PATIO DOOR SENSOR will need to be deleted

from BRIDGE.

ADDITIONAL INSTRUCTIONS (continued)

BATTERY

CIRCUIT BOARD

HINGED PATIO DOOR

OPEN/CLOSE SENSOR

HINGED PATIO DOOR

OPEN/CLOSE SENSOR BATTERY

PLASTIC

ENDCAP

SLIDING PATIO DOOR

OPEN/CLOSE SENSOR