Installation Guide

6
13
16
15
14
17
Push door tight against door frame. Install
door installation screws from Bag B on the
outer face of the hinge rail. Do not over
tighten screws.
Secure drip cap with installation screws from
Bag B. Remove and discard the spacer clips.
Caulk along top edge of drip cap if desired.
Rest the drip cap on top of the door, using spacers for
alignment. Close door and align the end of the drip cap
with the outside edge of the hinge rail.
Cut extender weather stripping to length,
remove adhesive backing and install.
Slide the remaining rail extender into the bottom of
the latch rail. For LEFT HINGE installation, use the
rail extender marked with an “R”. For RIGHT HINGE
installation, use the rail extender marked with an “L”.
Installation Screw
#8 x 3/4-in Pan Head
Qty.
5
Actual Size
Installation Screw
#8 x 3/4-in Pan Head
Qty.
3
Remove
clips after
installing
screws
Actual Size
Left Hinge
Right Hinge